top of page


- 120V/1Ph 10 Ft. commercial kitchen hood with right hand electrical (facing front of hood).
- 120V/1Ph exhaust fan and curb.
- 208V/3Ph direct fired make-up air unit, natural gas, with curb.
- 120V/1Ph Electrical control system.


Commercial kitchen hood packages can be customized to meet your commercial kitchen exhaust needs. Click the Request A Quote button above to submit your RFQ.


Hood Features
- FloAire 5424FX-2-PSP-F - 10ft 0" Long Exhaust-Only Wall Canopy Hood with 16" Wide Front Perforated Supply Plenum with Built-in 3" Back Standoff.
- 430 SS Where Exposed. 
- Utility Cabinet on the Right Side 12.00" Width x 54.00" Length x 24.00" Height. 
- FILTER - 16" tall x 16" (15.625" by 15.625") wide Stainless Steel Captrate Solo filter with hook, ETL Listed. Particulate capture efficiency: 85% efficient at 9 microns, 76% efficient at 5 microns. Used on hoods shipped AFTER 7/27/17.
- L55 Series E26 Canopy Light Fixture - High Temp Assembly, Includes Clear Thermal and Shock Resistant Globe (L55 Fixture), Bulbs By Others. 
- EXHAUST RISER - Factory installed 10" X 22" X 4". 
- SUPPLY RISER - 8"x 36" Supply Riser with Volume Dampers. 
- 1/2 Pint Grease Cup New Style, Flanged Slotted. 
- RIGHT VERTICAL END PANEL 27" Top Width, 21" Bottom Width, 80" High Insulated 430 SS. 
- Face Mount 1st Switch. 
- LEFT VERTICAL END PANEL 27" Top Width, 21" Bottom Width, 80" High Insulated 430 SS. 
- Face Mount Extra Switch(es). 
- Parts required to mount prewire sensor in capture volume of hood. Sensor installed directly in line with center of riser and in center of capture volume front to back. Sensor supplied from ECP tied to hood.
- Electrical Package Installation in Utility Cabinet by FloAire.


Rooftop Exhaust Fan Features

- Floaire DU85H High Speed Direct Drive Centrifugal Upblast Exhaust Fan with speed control (speed control included for single phase only), disconnect switch and 15-3/4" wheel.
- Exhaust Fan handles 2340 CFM @ -1.100" wc ESP, Fan runs at 1588 RPM.
- Exhaust Motor: 1.00 HP, 1 Phs, 115 V, 60 Hz, 11.6 FLA, TEAO-ECM (Totally Enclosed Air Over Electronically Commutated Motor).
- Grease Cup for kitchen-duty centrifugal exhaust fans, Box Dimensions 17-1/8 L X 5-1/16 W X 3-3/4 H (20 Gauge) (Includes Down Spout). 
- HINGE KIT - Standard Hinge kit for exhaust fan roof curbs. Includes Hardware to attach hinge to curb and hinge to base. Ships Loose. Used on Fans with wheels 20 inches or smaller. 12 GA Galvanized.
- ECM Wiring Package MODBUS Control for Exhaust EC motors. MSC Controller. 
- CAT-5E CABLE - 100 Foot. UV Rated. 
- Flat roof Curb CRB23X20E.
- Vented Base for Curb.


Rooftop Make Up Air Heater Features

- Floaire F1-D.500-15D Direct Gas Fired Heated Make Up Air Unit with 15" Mixed Flow Direct Drive Fan.
- Supply Fan handles 1872 CFM @ 0.300" wc ESP, Fan runs at 1874 RPM.
- Heater supplies 141317 BTUs. 70°F Temperature Rise.

- Fuel: Natural Gas.
- Supply Motor: 1.500 HP, 3 Phs, 208 V, 60 Hz, 4.4 FLA, ODP premium E-Plus3 efficiency.
- Down Discharge - Air Flow Right -> Left. 
- Sloped Filtered Intake for Size #1 Modular Heater. 21.813" Wide x 44.375" Long x 23.375" High.
- Includes 2" MV EZ Kleen Metal Mesh Filters.
- 0-150°F Discharge Temp Control.

- Field Wired On/Off Start Command

- Heating Activation Based On Intake Set Point. Use with MUA.
- Gas Manifold for DF1 GM - BTU 0 - 550001 - 7 in. w.c. - 14 in. w.c., No Insurance Requirement (ANSI), BV250-66.
- Down Discharge Construction for Size 1 Direct Drive AHUs. 
- Gas Pressure Gauge, 0-35", 2.5" Diameter, 1/4" Thread Size. 
- Gas Pressure Gauge, -5 to +15 Inches Wc., 2.5" Diameter, 1/4" Thread Size. 
- Low Fire Start. Allows the burner circuit to energize when the modulation control is in a low fire position.
- Ship Loose Gas Strainer. To be installed upstream of unit connection. 3/4" Connection. 
- Motorized Back Draft Damper 16" X 18" for Size 1 Standard & Modular Heater Units w/Extended Shaft, Standard Galvanized Construction, 3/4" Rear Flange, Low Leakage, TFB120S Actuator Included. 
- Freezestat With 10' Sensor. Factory set at 35°F and 10 minutes.
- Separate 120VAC Wiring Package for Make-Up Air Units. Option must be selected when mounting VFD in prewire panel or with DCV package. Provides separate 120VAC input to supply fan. This 120V signal must be run by electrician from DCV to mua switch.

- Flat roof curb CRB21X71X20INS, insulated.
- Full Bottom Curb Corner. Base flange corners fully welded or staked by factory.


Electrical Controls Features

- FloAire SC-311110MA 3 Phase w/ control for 1 Exhaust Fan, 1 Supply Fan, Exhaust on in Fire, Lights out in Fire, Relay On/Off with Supply Fan, Fan(s) On/Off Thermostatically Controlled.

- Room temperature sensor shipped loose for field installation. Includes 1 Duct Thermostat kit.

- ESV112N01SXB571 - Variable Frequency Drive - 1-1/2 HP Max., 240/120 V, Single Phase, 6.0 A Max., NEMA 1 Enclosure, with 2RJ-45 FOR MODBUS - 120v 1ph.

- Digital Prewire Lighting Relay Kit. Includes hood lighting relay & terminal blocks. Allows for up to 1400W of lighting each.
- Thermistor CABLE - 18/2 AWG GREEN WHITE, plenum rated. USED for thermistor duct stat.
- CAT-5E CABLE - 100 Foot. UV Rated.

FloAire 10Ft Heated Kitchen Hood Package With Right Hand Electrical Control

SKU: FloAire-10Ft-Heated-UC-Right
    bottom of page